Перевод описания настроичных параметров 3G всем миром.

Sidches

Хиллер-Бэлл уже есть, вот дальше:

Компенсация шага:
Если во время быстрого пролета вперёд, изменение коллективного шага приводит к раскачиванию вертолета вверх-вниз, этот параметр может быть увеличен, чтобы повысить устойчивость вертолета.

Oleg_A

Pirouette Optimum Adjustment
This parameter is used to compensate for drifting of the heli during pirouetting maneuvers,
ideal setting would keep the helicopter stationary during pirouetting maneuvers,
and assist the pilot to maintain a straight course during pirouetting forward flight.
But excessive value may result in overcorrection by the 3G system, causing unusual
behaviors in flips and rolls.

Cyclic Pitch Motion Delay
This setting softens the cyclic action, causing the helicopter to resemble closer to
traditional flybar system. Hard 3D Flyers can lower this value, while more docile
type of flying can increase this value.

ДмитрийС

И после такого набора настроечных параметров народ еще ругает 3G…

“Вы не любите кошек??? Да Вы просто не умеете их готовить!!!”

Sidches

Мне кажется, что многим легче поскулить на форуме, чем взять один раз на поле ноутбук и потратить один пак на настройки, вот и все, банальная лень 😉

Oleg_A

Elevator parameters

Elevator Control Rate
Helicopter flip rate is a personal preference. This parameter is used to compensate
for insufficient flip rate setting no your radio. For example. when the ELE SWASH AFR
is set to the maximum value on your radio, but higher flip rate is still desired, this value
can be increased to achieve even higher flip rate. On the other hand, even though the
radios ELE SWASH AFR can be used for lower flip rate. too low of SWASH AFR value will
reduce command resolution (do not lower past 50%) instead, use this elevator command
compensate parametr to reduce flip rate, while maintaining command resolution.
The actual flip rate after compensation will be displayed in “Command display.”
Note: If the flip rate is still insufficient after increasing this parameter. there may not be
enough cyclic pitch, but not exceeding the maximum pitch as recommended in the manual.

Elevator Total Gain Compensate
A helicopters gain may be attributed to factors such as servo arms length,
helicopter size, etc. This parameter is used to compensate for insufficient ELE gain
setting on your 3G control-unit. For example, when more gain is needed past the
3G control-unit maximum ELE gain setting. User should try to set the aileron gain
compensate value so that the physical dial on 3G control-unit is approximately
in the middle. so the gain resolution is maintained, and there are room for fine
adjustments using the dial.

Sidches
Oleg_A:

Elevator parameters

Олег, параметры элеватора, практически идентичны элеронам, т.ч. нет смысла их переводить, имхо 😉
Спасибо за помощь!

1 month later